Procom EDP200T2-C Specifiche

Questions about installation, operation, or troubleshooting? Before return

Minimum Wall and Ceiling Clearances (See Figure 4) A. Clearances from outermost point of fireplace to any combustible side wall should not be less th

INSTALLATION CONTINUED The installer must supply an external regulator. The external regulator will reduce incoming gas pressure.

INSTALLATION CONTINUED CAUTION: Two gas line installations at the same time are forbidden. Do not open cover while the heater is running. Heater is

CHECKING GAS CONNECTIONS WARNING: Test all gas piping and connections for leaks after installing or servicing. Correct all leaks immediately. Press

INSTALLING LOGS WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts may result in property damage o

STEP 3: Insert the two pins on the bottom of log 3 into the two holes on firebox floor. STEP 5: Insert the

OPERATING HEATER WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury o

1. STOP! Read the safety information on page 3. 2. Unscrew ignitor cap and install a AAA type battery with its anode (“+”) pointing out. Replace

(Match Light) 1. Remove screen by lifting and pulling forward. 2. Follow steps 1 through 7 under MANUAL OPERATING Lighting Instructions. 3. With

CARE AND MAINTENANCE WARNING: Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shook or personal

TABLE OF CONTENTS Important Safety Information...

TROUBLESHOOTING NOTE: Turn the control knob to “OFF” position first and wait for one minute. Then turn the control knob to the “ON” position. Plea

OBSERVED PROBLEM REMEDY POSSIBLE CAUSE ODS/pilot lights but flame goes out when control knob is released. 1. Control knob is not fully pressed in.

OBSERVED PROBLEM REMEDY POSSIBLE CAUSE White powder residue forming within burner box or on adjacent walls or furniture 1. When heated, the vapors

REPLACEMENT PARTS NOTE: Use only original replacement parts. This will protect your warranty coverage for parts replaced under warranty. PARTS UNDER

PARTS LIST This list contains replaceable parts used in your heater. When ordering parts, follow the instructions listed under Replacement Parts on

PARTS LIST EDP200T2-O & EDP200T2-C This list contains replaceable parts used in your heater. When ordering parts, follow the instructions listed

EDP200T2-O & EDP200T2-C 26

PARTS LIST EDS200T2-HC This list contains replaceable parts used in your heater. When ordering parts, follow the instructions listed under Replacemen

IMPORTANT SAFETY INFORMATION IMPORTANT: Read this owner’s manual carefully and completely before trying to assemble, operate, or service this heater.

1. Do not place Propane/LP supply tank(s) inside any structure. Propane/LP supply tank(s) must be placed outdoors. 2. This heater shall not be insta

PRODUCT FEATURES SAFETY PILOT This heater has a pilot with an Oxygen Depletion Sensing (ODS) safety shutoff system. ODS/pilot is a required feature

UNPACKING 1. Remove top inner pack. 2. Tilt carton so that heater is upright. 3. Remove protective side packaging. 4. Slide heater out of carton. 5.

AIR FOR COMBUSTION AND VENTILATION WARNING: This heater shall not be installed in a confined space or unusually tight construction unless provision

2. Divide the space volume by 50 cubic feet to determine the maximum BTU/hr the space can support. (Volume of space) ÷ 50 cu. ft. = (Maxi

Ventilation Air from Outdoors Provide extra fresh air by using ventilation grills or ducts. You must provide two permanent openings: one within 12&qu